Spring sale discount off 3%! coupon code: s3

Mini Cart

Sale

TMC2225 Stepper Motor Driver StepStick 3D printer parts ultra silent For SGen_L Gen_L Robin Nano

$8.99 $2.99 Save 67%

Description

Overview:

Tmc2225 is the next generation product to replace tmc2208, have better price and all function of tmc2208. The only difference between TMC2225 and TMC2208 is package.The package of TMC2225 is HTSSOP,and the package of TMC2208 is QFN, so TMC2225 have better heat dissipation performance.

Features:

  1. Ultra quiet
  2. Large heat sink,good heat dissipation
  3. Support uart mode by set jumper caps instead of welding on mks gen_l V2.0,skr1.3/1.4,mks sgen_l.

Parameter:

  1. Default current:1.25a
  2. Max current:2.0a
  3. Logic voltage:3.3v/5v
  4. Input voltage:4.75v-36v
  5. Microstep:up to 1/256
  6. Mode:dir/step,uart

Microstep set:

Microstep setting
M0 M1 STEP
GND GND 4
VCC-IO GND 8
GND VCC_IO 16
VCC_IO VCC_IO 32

Driver current regulation:

  1. Verf measures the voltage of Gnd and potentiometer middle.
  2. Please DO NOT connect the motors when measuring the voltage, or it’s easy to burn the drive.
  3. Please connect the power supply when measuring voltage as well, do not connect only the USB power.
  4. Please pay special attention to the direction, do not insert wrongly!

Driver current algorithm:

I = Vref    Default I = 1.25A

Notice:

  1. Pay attention to the connection direction,do not reverse it.
  2. The motor direction is opposite to that of A4988 and DRV8825, please adjust the firmware or adjust the motor wiring if you want to change A4988.
  3. Dir/step mode used in the printer control board, please pay attention to set the jumper cap MS1 MS2.

Uart mode:

Uart mode can be used on mks gen_l(v2.x),mks sgen_l,skr1.3/1.4 by set jumper cap like below: MKS Sgen_L / MKS Gen_L:
SKR 1.3/1.4:

Reviews

There are no reviews yet.

Be the first to review “TMC2225 Stepper Motor Driver StepStick 3D printer parts ultra silent For SGen_L Gen_L Robin Nano”

Your email address will not be published. Required fields are marked *